2003 Subaru Impreza

All underbody heavily undersealed

Rear all suspension components corroded

all underbody heavily undersealed

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension component mounting repair covered in underseal all (5.3.6 (a) (i))

Horn not working (7.7 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill behind rear wheel (6.1.1 (c) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

both front strut top mounts very noisy

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill behind wheel (6.1.1 (c) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill/wheelarch (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill/wheelarch (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened both rear (1.1.14 (a) (ii))

both front strut top mounts very noisy

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Sills corroded

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Sills corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Sills corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Sills corroded

Brake pipe excessively corroded Both Centre Rear (1.1.11 (c))

Brake pipe excessively corroded Both rear (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Brake hose excessively twisted (1.1.12 (b) (ii))

Power steering malfunctioning (2.1.5 (a))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear inner sills corroded

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

high level stop lamp inop

front brake pads getting low

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)