2006 Mazda 6

Emissions not tested exhaust blowing not allowing correct measurement of gases (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

all rear suspension bushes heavily deteriorated

exhaust has slight blow in rear v section

clunk on steering column but no play

exhaust bracket snapped off from rear of offside back box

nearside front tyre worn on outer edge

nearside front washer jet requires slight adjustment

offside rear brake disc has surface corrosion to outer face

slight blow from exhaust v section at the rear

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

child seat fitted preventing full seat belt inspection

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp not working on dipped beam (1.7.5a)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp not working on dipped beam (1.7.5a)