2002 Mercedes-benz Slk

Nearside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Play in steering rack inner joint(s) both ()

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Play in steering rack inner joint(s) ()

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Suspension arm corroded but not seriously weakened front & rear (5.3.3 (b) (i))

Tyre slightly damaged/cracking or perishing all (5.2.3 (d) (ii))

Nearside Front Inner Steering linkage ball joint has slight play (2.1.3 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Inner Steering linkage ball joint has slight play (2.1.3 (b) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front drivers door stiff to open

under side heavley under sealed

slight corrosion underneath

surface corrosion on underside from standing

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Battery insecure.

Front tyres worn on inner edges.

Slight play in both sides front wheel bearings.

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)