2003 Suzuki GZ125

Chain guard missing ()

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front mudguard missing

Chain guard missing ()

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front mudguard missing

Rear reflector missing (4.8.2 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake component insecure rear brake anchorage (1.1.21 (c))

Drive chain slightly loose (6.2.1d)

Drive chain sprocket carrier worn but not considered excessive sproket carrier rubbers slightly worn (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Front Brake fluid reservoir fluid level low (3.2.B1d)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Roller brake test indicates a binding brake (3.3.A1a)

Engine oil level overfilled.

Front lower engine mounting bolt loose.

Front wheel bearings are slightly rough (2.3.5b)

Drive chain sprocket carrier worn but not considered excessive rubbers (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Brake reaction bracket securing bolt(s) missing (3.2.A1j)

Drive chain excessively loose (6.2.1d)

Nearside Rear Direction indicator insecure (1.5.3b)

Drive chain sprocket carrier worn but not considered excessive rubbers (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Lower Motorcycle structure slightly corroded (6.1.1a)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Drive chain slightly tight (6.2.1d)

Lower Motorcycle structure slightly corroded (6.1.1a)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Drive chain worn but not considered excessive (6.2.1e)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear Stop lamp remains on when the brake is released (1.3.1e)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front Front shock absorber seal failed and leaking oil (2.3.3)

Fuel cap mounting flange/sealing method defective (7.2.2c)

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Exhaust has part of the system missing (7.1.1a)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i))

Front shock absorber seal failed and leaking oil (2.3.3)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front wheel spindle loose (2.3.3a)