2007 Mercedes-benz Vito

Front All position lamps have a product on the lenses but not adversely affecting light output Both (4.2.3 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Registration plate inscription illegible delaminated (0.1 (b))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

handbrake reserve travel needs adusment

Nearside Front Position lamp not working (4.2.1 (a) (ii))

handbrake reserve travel needs adusment

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive Rear Differential (8.4.1 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive Rear Differential (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension rod ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front All direction indicators slightly discoloured (4.4.3 (a))

Offside Front All direction indicators slightly discoloured (4.4.3 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

dampness oil stain o/s/f recommend further investigation

engine oil on minimum

steering feels slightly rough & noisy recommend further investigation

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Stop lamp not working (1.2.1b)

dampness oil stain o/s/f recommend further investigation

engine oil on minimum

steering feels slightly rough & noisy recommend further investigation

Offside Front Outer Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

all 4 tyre outer walls poor suspect rubbing against curb

Offside Stop lamp not working (1.2.1b)

all 4 tyre outer walls poor suspect rubbing against curb

van retested with center brake light diconected

Brake fluid warning lamp illuminated (3.6.G.2)

Centre Stop lamp not working (1.2.1b)

Offside Rear coil spring incomplete (2.4.C.1a)

Offside Track rod end ball joint has excessive play (2.2.B.1f) DANGEROUS

brake pedal traval close to maximum

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s/f tyre wearing on outter edge

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)