2007 Volkswagen Polo

Brake lever has insufficient reserve travel (1.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Exhaust has a major leak of exhaust gases Box (6.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Outer Sill corroded

Play in steering rack inner joint(s) ()

Exhaust has a minor leak of exhaust gases back box, outer casing rusty (6.1.2 (a))

Offside Front Inner Steering linkage ball joint has slight play tie rod (2.1.3 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Play in steering rack inner joint(s) ()

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front C.v joint noisy

Front Headlamp not working on main beam (4.1.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front C.v joint noisy

exhaust system CENTRE SECTION is blowing slightly

exhaust system LAMBDA SENSOR is slow to clear! see emissions printout and blowing centre section

handbrake lever has lots of free travel indicating rear brakes require attention/adjustment

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge 2-3mm. remaining (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge 2-3mm. remaining (5.2.3 (e))

exhaust system CENTRE SECTION is blowing slightly

exhaust system LAMBDA SENSOR is slow to clear! see emissions printout and blowing centre section

handbrake lever has lots of free travel indicating rear brakes require attention/adjustment

Nearside Rear near side rear tyre cracking in side wall.

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

fuel cap seal cracking but is sealing at time for test.

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear near side rear tyre cracking in side wall.

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

fuel cap seal cracking but is sealing at time for test.

Front Brake lining(s) wear indicator illuminated (1.1.13 (a) (i))

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

both front tyres wearing close to legal limit

front brake pad sensor damaged

offside rear tyre heavily worn inner edge

washer pipe damaged

Offside Front Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Play in steering rack inner joint(s) ()

smear on wipers

Both Front Wiper blades poor

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Both Front Wiper blades poor

offside rear tyre tread is cracking

offside rear tyre tread is cracking

off side rear tyre cracking

Brake servo vacuum pipe split (3.6.C.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)