2008 Toyota Aygo

Front Brake pad(s) wearing thin both side (1.1.13 (a) (ii))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Shock absorbers has a slightly worn bush both side (5.3.2 (c))

both side sills corroded

Emissions unable to be completed (8.2.2.2 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting sill has hole (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin both side (1.1.13 (a) (ii))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Shock absorbers has a slightly worn bush both side (5.3.2 (c))

both side sills corroded

General under-body corrosion all around

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Coil spring corroded Both (5.3.1 (b) (i))

General under-body corrosion all around

Nearside Front All direction indicators not working (4.4.1 (a) (ii))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Front Position lamp not working both (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure cut around side wall down to cords (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing 155/65/14 (5.2.3 (d) (ii))

Nearside Headlamp aim too far to the right (4.1.2 (a))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing 155/65/14 (5.2.3 (d) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Exhaust system not adequately supported center to front pipe (7.1.1)

Front registration plate deteriorated (6.3.1d)

Nearside Brake pipe excessively corroded front to rear (3.6.B.2c)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords outer sidewall (4.1.D.1a)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Front exhaust mounting bracket broken

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

wiper poor

brake discs lipped on edges slightly

tested in wet conditions

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brake discs heavily lipped on edges