2009 Hyundai I10

Front Brake disc worn, pitted or scored, but not seriously weakened O/S and N/S (1.1.14 (a) (ii))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material O/S and N/S (1.1.11 (c))

Rear Coil spring corroded O/S and N/S (5.3.1 (b) (i))

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge wearing inside edge badly (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre has ply or cords exposed also worn on inner edge (4.1.D.1b)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre has ply or cords exposed also worn on inner edge (4.1.D.1b)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Brake hose slightly deteriorated (3.6.B.4d)

Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

coil spring corroded (2.4.C.1b)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Brake hose slightly deteriorated (3.6.B.4d)

Front Brake pad(s) wearing thin (3.5.1g)

coil spring corroded (2.4.C.1b)

Exhaust engine idle speed too high (7.3.D.1)

Brake hose has slight corrosion to ferrules (3.6.B.4e)

Brake hose slightly deteriorated (3.6.B.4d)

Front Brake pad(s) wearing thin (3.5.1g)

coil spring corroded (2.4.C.1b)

could not do emissions test due to engin not holding revs at fast idle .. engin would rev to high when trying to get to pre set speed will not hold pre set speed..will ether rach on or die away'''

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both front tyres cracking

nail in nsr tyre

oil light flashing

osf tyre worn on inner