2016 Isuzu D-max

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Steering system slightly rough (2.1.1 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect clean (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect clean (4.1.2 (c))

Offside Front Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Brake pipes corroded

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Brakes imbalanced across an axle 46% o/s lower (1.2.1 (b) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pipes corroded

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Offside Front front fog not working

Nearside Front Bumper insecure (6.1.4 (a) (i))

Offside Front Bumper insecure (6.1.4 (a) (i))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Offside Front front fog not working