2003 Peugeot 206

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Brake pipe excessively corroded rear brake pipes corroded x 4 (1.1.11 (c))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Brake valve leaking such that brake functionality is affected wheel cylinder leaking (1.1.7 (d) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

fuel tank strap corroded

rear suspension bump stops missing

rear wiper blade torn

Offside Front Steering linkage ball joint has slight play (2.1.3 (b) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a major leak of exhaust gases clamp broken (6.1.2 (a))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor holed (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chassis holed (6.2.2 (d) (i))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor holed (6.2.2 (d) (i))

Brake pipe corroded, covered in grease or other material Front to brake load sense valve pipes covered in paint and sealer (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake load sensing valve stiff (3.6.E.3)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm has slight play in a pin bearing (2.4.G.2)

Play in steering rack inner joint(s) ()

nearside rear tyre worn close to the legal limit / perished / cracked

Front Brake hose has slight corrosion to ferrules Both sides (3.6.B.4e)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Exhaust system not adequately supported (7.1.1)

Offside Rear wheel bearing rough when rotated (2.6.1)

Front Brake hose has slight corrosion to ferrules Both sides (3.6.B.4e)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Rear Brake pipe excessively corroded (3.6.B.2c)

Side repeater incorrect colour (1.4.A.2f)

Nail in nearside front tyre

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake lever has little reserve travel (3.1.6b)

Front Brake pad(s) wearing thin (3.5.1g)

spare wheel and tool kit insercure under vehicle