2004 Honda Civic

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge on limit (5.2.3 (e))

Rear Body component slightly loose exhaust heat shield (6.2.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive surface corrosion, under seal and previous repairs through out (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Lower Suspension locking device missing ball joint nut split pin missing (5.3.6 (b))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Inner Integral body structure inadequately repaired such that it is likely to adversely affect braking or steering sill not continuously welded (6.1.1 (d) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on legal limit (5.2.3 (e))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Body component slightly loose exhaust heat shield (6.2.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced heavily corroded and under sealed at rear (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Electrical wiring insecure and connectors likely to become disconnected battery terminal (4.11 (a) (ii))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm pin or bush excessively worn front bush (5.3.4 (a) (i))

Nearside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on legal limit (5.2.3 (e))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Body component slightly loose exhaust heat shield (6.2.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced heavily corroded and under sealed at rear (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill to floor (6.1.1 (c) (i))

Nearside Parking brake inoperative on one side handbrake (1.4.1 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis near suspension mount (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill to floor (6.1.1 (c) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm 195/60/15 (5.2.3 (e)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm pin or bush excessively worn front bush (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too high (1.8)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Rear Lower Anti-roll bar linkage fractured (2.4.G.1)

All tyres are getting close to 2mm wear indicator