2006 Peugeot 107

Offside Front Coil spring corroded (5.3.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r & o/s/r (1.1.11 (c))

Rear Coil spring corroded n/s/r & o/s/r (5.3.1 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn Both (5.1.2 (b) (i))

Rear Shock absorbers has a slightly worn bush Both (5.3.2 (c))

Suspension component mounting repair covered in underseal Offside rear of sill (5.3.6 (a) (i))

Underbody of vehicle rusty

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn Both (5.1.2 (b) (i))

Rear Shock absorbers has a slightly worn bush Both (5.3.2 (c))

Suspension component mounting repair covered in underseal Offside rear of sill (5.3.6 (a) (i))

Underbody of vehicle rusty

Nearside Rear Service brake excessively binding (1.2.1 (f))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Nearside outer rear of sill (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Offside inner rear of sill (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Offside rear end of sill/wheel arch (5.3.6 (a) (i))

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both front (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Suspension arm pin or bush worn but not resulting in excessive movement Both front lower arms rearward bushes (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front suspension components corroded but can still function as intended

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear suspension components corroded but cans till function as intended

Front suspension components corroded but can still function as intended

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear suspension components corroded but can still function as intended

exhaust system corroded

Rear Emissions not tested exhaust leak (8.2.1.2 (d))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

limited inspection of brake pipes due to a coating of protective sealant

Front Brake pad(s) wearing thin (3.5.1g)

Vehicle's internal headlight adjuster altered to recheck lights

o/s and n/s front brake discs scored and pitted inside surface