2007 Ford Focus

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security undersurface, sills, sub-frame (6.2.2 (d) (i))

Front Lower wings rusted/holed

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Front Brake pad(s) wearing thin Approximately 4mm lining remaining (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge Worn on the inner edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Front Brake pad(s) wearing thin Approximately 4mm lining remaining (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge Worn on the inner edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Exhaust noisy (8.1.1 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill area (6.1.1 (c) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill area (6.1.1 (c) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Suspension arm has excessive play in a pin/bush rear bush (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened inner face (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened inner face (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

offside rear tyre wearing on inner edge

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

offside rear tyre wearing on inner edge

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

slight damage to nearside front tyre outer side wall

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

slight damage to nearside front tyre outer side wall

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)