2009 Fiat Grande Punto

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Front both under arches loose

Items removed from driver's view prior to test ()

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Road wheel slightly distorted damage on side (5.2.2 (c) (i))

Nearside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases back box joint (6.1.2 (a))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement BOTH FRONT LOWER - REAR BUSH (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Stop lamp(s) missing (4.3.1 (a) (ii))

Suspension arm pin or bush worn but not resulting in excessive movement BOTH FRONT LOWER - REAR BUSH (5.3.4 (a) (i))

Coil spring corroded BOTH REAR (5.3.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Anti-roll bar linkage ball joint excessively worn BOTH FRONT (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear fog lamp does not emit a steady red light (4.5.4 (a))

Coil spring corroded BOTH REAR (5.3.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front brake pad warning wire broken

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Central Rear Seat belt buckle missing (7.1.2 (d))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Oil leaking excessively from engine (8.4.1 (a) (i))

Items removed from driver's view prior to test ()

Nearside Front brake pad warning wire broken

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too low (1.8)

Slight corrosion on rear exhast box

rear exhaust silencer corroding

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

rear exhaust silencer corroding