2008 Mazda 3

Emissions not tested due to exhaust leak (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength trailing arm (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength trailing arm (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced underside of vehicle (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

extensive corrosion to vehicle underside

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected floor (5.3.6 (a) (ii)) DANGEROUS

extensive corrosion to vehicle underside

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

corrosion to vehicle underside

Nearside Front Anti-roll bar synthetic mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Anti-roll bar synthetic mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)