1986 Cz 125

Front Brake cable damaged but not to excess outer casing (1.1.15 (a))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Headlamp reflector slightly defective (4.1.1 (b) (i))

Steering headbearing has slight free play (2.2.2 (f) (i))

n/s front fuel tank missing

rear lower engine bolt missing

throttle cable outer casing worn

ware in rear sprocket damper rubbers

Drive chain excessively loose (6.1.7 (c) (i))

Front Wheel bearing has excessive play (5.1.3 (a) (i))

Rear Brake pedal pivot excessively worn (1.1.1 (b))

Front Brake cable damaged but not to excess outer casing (1.1.15 (a))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Headlamp reflector slightly defective (4.1.1 (b) (i))

Steering headbearing has slight free play (2.2.2 (f) (i))

n/s front fuel tank missing

rear lower engine bolt missing

throttle cable outer casing worn

ware in rear sprocket damper rubbers

Drive chain worn but not considered excessive (6.2.1e)

Exhaust noisy (7.1.2)

Front Brake component damaged but not seriously reduced in strength brake cable outer (3.2.A1)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Tyre worn close to the legal limit (4.1.3(ii))

Nearside Headlamp deteriorated but function not impaired bracket (1.2.3a)

Rear Drive chain sprocket carrier worn but not considered excessive (6.2.1e)

clutch cable frayed

front fuel mount missing

Exhaust noisy (7.1.2)

Front Brake cable outer casing slightly damaged (3.2.A1b)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Offside Front suspension assembly slightly corroded. (2.3.1)

clutch cable fraying

n/s fuel tank mounting missing

n/s headlamp bracket damaged

throttle cable outer frayed

Direction indicator not working (1.5.1c)

Horn not working (1.7.3a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front wheel bearings are slightly rough (2.3.5b)

Steering headbearing has slight free play (2.2.2)

Direction indicator not working (1.5.1c)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Stop lamp remains on when the brake is released (1.3.1e)

Drive chain sprocket carrier worn but not considered excessive (6.2.1e)

Fuel tank missing left hand securing bolt

Offside Front suspension assembly slightly corroded. (2.3.1)

Direction indicator not working (1.5.1c)

Drive chain sprocket carrier worn but not considered excessive (6.2.1e)

Fuel tank missing left hand securing bolt

Offside Front suspension assembly slightly corroded. (2.3.1)

Front Brake lever pivots slightly worn (3.1.3a)

Rear wheel bearings have slight free play (2.4.A.2c)

clutch lever pivot worn

Stop lamp flickers when tapped lightly by hand (1.3.1d)

Front Brake lever pivots slightly worn (3.1.3a)

Rear wheel bearings have slight free play (2.4.A.2c)

clutch lever pivot worn

Front mudguard insecure (2.3.7)

Nearside Front Direction indicators not working (1.5.1c)

Nearside Front Footrest insecure (6.2.1a)

n/s drivers footrest damaged

Direction indicator affected by the operation of another lamp (1.5.1c)

Direction indicator flashing less than 60 times a minute (1.5.1c)

Registration plate with character(s) which are not the correct width (6.3.4a)

n/s drivers footrest damaged

Clutch lever bent (6.2.1g)

Exhaust is leaking and excessively noisey (7.1.1b)

Floor brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.C1b)

Front Brake lever has inadequate reserve travel (3.1.3b)

Front suspension assembly has an insecure fork brace (2.3.4d)

Offside Rear Direction indicator not working (1.5.1c)

Rear Tyre has ply or cord exposed (4.1.2a(iii)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear reflector on motorcycle missing (1.4.1)

Clutch lever bent (6.2.1g)