2003 Mazda RX-7

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Fuel Pipe/s corroded ()

general corrosion to underside of vehicle

Front tyres starting to perish in tread cuts

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases downpipe (6.1.2 (a))

Nearside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Offside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm inner edge (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm inner edge (5.2.3 (e)) DANGEROUS

Front tyres starting to perish in tread cuts

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area repaired, but not inappropriately (2.4.A.3)

both front inner wheel arch liners and outer side skirt covers slightly damaged

both rear tyres heavily worn on inner edges

car has been built for track use

front and rear brake discs slightly worn

n/s/r side lights slightly deteriorated

oil leak

rear brake pads wearing thin

rear brake pads wearing thin

slight play in both front anti roll bar drop link bushes

very slight corrosion in all brake pipes

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front inner wheel arch liners and outer side skirt covers slightly damaged

both rear tyres heavily worn on inner edges

car has been built for track use

front and rear brake discs slightly worn

n/s/r side lights slightly deteriorated

oil leak

rear brake pads wearing thin

rear brake pads wearing thin

slight play in both front anti roll bar drop link bushes

very slight corrosion in all brake pipes

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear Tyre worn close to the legal limit slighty wearing on inner edges (4.1.E.1)

Rear advises number plate light cover missing

advises outer sill covers fitted

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Track rod end ball pin shank loose track rob end missing split pin (2.2.B.1c)

Offside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear Tyre worn close to the legal limit slighty wearing on inner edges (4.1.E.1)

Rear advises number plate light cover missing

advises outer sill covers fitted

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Brake fluid warning lamp illuminated (3.6.G.2)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust noisy (7.1.4)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Oil leak

o/s/r track rod end slight movement

Windscreen washer provides insufficient washer liquid (8.2.3)

headlight lenses taped to create flat beam image