1987 Peugeot 205

Horn not working (7.7 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Windscreen washer not working (3.5 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Upper Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill small hole. (6.1.1 (c) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp are incorrectly positioned (4.1.4 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brakes imbalanced across an axle by more than 50% Axle 1 (1.2.1 (b) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear boot floor has hole due to corrosion

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill panel (6.2.2 (d) (i))

unable to test nearside front wheel bearing due to brake bind

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp are incorrectly positioned (4.1.4 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brakes imbalanced across an axle by more than 50% Axle 1 (1.2.1 (b) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear boot floor has hole due to corrosion

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill panel (6.2.2 (d) (i))

unable to test nearside front wheel bearing due to brake bind

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front suspension has a suspension lower ball joint securing nut loose (2.5.B.1a)

Nearside Front suspension has excessive movement at a suspension ball joint (2.5.A.1c)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

both front tyres splitting

rear silencer rubber splitting

Battery insecure (1.9.1)

Horn not working (1.6.2a)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Rear Brake pipe inadequately supported (3.6.B.1)

Offside Rear Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Windscreen washer provides insufficient washer liquid (8.2.3)

both front tyres splitting

rear silencer rubber splitting

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Exhaust engine idle speed too high (7.3.A.2a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Suspension arm attachment bracket/mounting insecure (2.4.G.1)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Exhaust engine idle speed too high (7.3.A.2a)

Horn not working (1.6.2a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear brake caliper has restricted free movement (3.5.1k)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)