1988 Citroen C25

Brake pipe corroded, covered in grease or other material front to rear, front section (1.1.11 (c))

Nearside Front Lower Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Upper Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Wheel bearing has slight play Both (5.1.3 (a) (i))

offside front headlamp output slightly weak

surface corrosion steering and suspension components

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Nearside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Brake servo retaining device insecure (3.6.A.2d)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Seat belt affected by an insecure seat fixing (5.2.1b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Lower Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Items removed from driver's view prior to test

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear registration plate character(s) likely to be misread (6.3.4b)

Items removed from driver's view prior to test

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust mounting missing

Oil leak

Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Wire cable tied to offside handbrake cable

Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Headlamp not working on dipped beam (1.7.5a)

Side repeater not working (1.4.A.2c)

Stop lamp not working (1.2.1b)

Oil leak

Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Wire cable tied to offside handbrake cable

Direction indicators flashing less than 60 times a minute (1.4.A.2g)

Emissions not tested (7.0)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

Front brake disc slightly pitted (3.5.1h)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear wheel bearing rough when rotated (2.6.1)

Front brake disc slightly pitted (3.5.1h)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front wheel bearing has slight play (2.5.A.3c)