1986 Volkswagen Polo

Both front suspension atop mounts have slight play

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Both front suspension atop mounts have slight play

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Brake hose slightly twisted (1.1.12 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge very close to limit inner edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge very close to limit inner edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material from flexi (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Brake pipe corroded, covered in grease or other material from flexi (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i))

Main beam tell-tale not working (4.9.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Speedometer cannot be illuminated (7.8 (c) (ii))

Nearside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Outer Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. car has been stood (1.2.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive inner outer sill areas (5.3.6 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. car has been stood (3.7.B.5b)

Horn not working (1.6.2a)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt both sides (2.5.C.1a)

Battery insecure (1.9.1)

Brake pedal spongy (3.3.B.1b)

Braking system leaking master cylinder into car (3.6.A.1)

Fuel tank leaking fuel neck area (7.2.3)

Hazard warning lamps inoperative (1.4.B.1b)

Horn not working (1.6.2a)

Nearside Rear rear brake binding (3.7.B.1)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Rear Stop lamp not working (1.2.1b)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt both sides (2.5.C.1a)

Offside Front Tyre worn close to the legal limit worn inner edge (4.1.E.1)