1994 Mazda MX-5

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Upper Macpherson strut mounting damaged but not seriously weakened (5.3.3 (b) (i))

under the chassis general corrosion

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

General underbody corrosion

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

general underside surface corrosion

General underside corrosion

Nearside Front Lower wing corroded

Offside Front Lower wing corroded

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

General underside corrosion

Nearside Front Lower wing corroded

Offside Front Lower wing corroded

Rear Suspension arm pin or bush worn but not resulting in excessive movement suspension bushes perishing (5.3.4 (a) (i))

general underside surface corrosion

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced ns sill corroded within 30cm of seat belt mounting (7.1.1 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect kick up to the right (4.1.2 (c))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect kick up to the right (4.1.2 (c))

Offside Rear Rear reflector missing (4.8.2 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Brake pipe corroded, covered in grease or other material front to rear corroded (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

note o/s/f and n/s/f position lights not in casings

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component attachment bracket/mounting likely to become detached suspension strengthener mounting bolt insecure (5.3.3 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

note o/s/f and n/s/f position lights not in casings

Parking brake: efficiency below requirements (3.7.B.7)

Front front suspension corroded

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

general underside corrosion

rear parking (secondary) brake grabbing slightly (3.7.B.6b)

surface corrosion to underside

Nearside Rear Inner Subframe mounting prescribed area is excessively corroded (2.4.A.3)

surface corrosion to underside

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front coil spring corroded (2.4.C.1b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Body has slight corrosion (6.1.B.2)

Parking brake lever has little reserve travel (3.1.6b)

Rear Tyre worn close to the legal limit (4.1.E.1)

front brake juddering slightly (3.7.A.2b)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

extensive surface corrosion on all lower suspension joints

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear coil spring fractured (2.4.C.1a)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

all suspension components badly corroded

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

all suspension components badly corroded

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Headlamp not working on dipped beam (1.7.5a)

long hand brake travel

offside rear outter door seal serface rust

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

long hand brake travel

offside rear outter door seal serface rust

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear coil spring fractured (2.4.C.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

suspension components rusty