1986 Land Rover Defender

Brake pipe clips or supports missing, pipe adequately supported Front to rear brake pipe. (1.1.11 (d) (i))

Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear axle bump stop missing.

Hazard warning lamps inoperative (4.4.1 (e))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Nearside Rear axle bump stop missing.

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i))

Nearside Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Headlamp lens slightly defective condensation on lens. (4.1.1 (b) (i))

Prop shaft joint worn, but not excessively Front shaft front joint (6.1.7 (c) (i))

Prop shaft joint worn, but not excessively rear shaft front joint (6.1.7 (c) (i))

Hazard warning switch faulty (4.4.2 (a) (i))

Indicator tell-tale inoperative (4.9.1 (a) (i))

inner front pads wearing low

slight pas fluid leak

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Indicator tell-tale inoperative (4.9.1 (a) (i))

inner front pads wearing low

slight pas fluid leak

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Power steering component(s) has slight seepage from a component steering box (2.3.3b)

both o/s/r & n/s/r rear axle wishbone mounting bolts 1 of the 3 is not in contact with nyloc

center body mounting bolts missing , both o/s & n/s

Power steering component(s) has slight seepage from a component steering box (2.3.3b)

Rear fog lamp not working (1.3.2b)

both o/s/r & n/s/r rear axle wishbone mounting bolts 1 of the 3 is not in contact with nyloc

center body mounting bolts missing , both o/s & n/s

Registration plate lamp not working (1.1.5c)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Service brake: efficiency below requirements (3.7.C.1a)