1986 Austin Mini Mayfair

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Upper Suspension component ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension component ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Vehicle structure has slight corrosion jacking point (6.1.B.2)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Vehicle structure has slight corrosion jacking point (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Rear Sub-frame attachment bracket/mounting insecure (2.4.G.1) DANGEROUS

Coolant leak

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Front constant velocity joint is insecure (2.5.C.1b)

Nearside Front front brake binding (3.7.B.1)

Offside Front Front constant velocity joint is insecure (2.5.C.1b)

Offside Front front brake binding (3.7.B.1)

Front Bonnet retaining device ineffective (8.4.2)

Front registration plate missing (6.3.1a)

Nearside Front Windscreen wiper blade missing (8.2.2)

Offside Front Windscreen wiper blade missing (8.2.2)

Rear registration plate missing (6.3.1a)

Rear Rear fog lamp not working (1.3.2b)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Direction indicators flashing less than 60 times a minute (1.4.A.2g)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Headlamp aim too low (1.8)

Oil leak

Rear Rear fog lamp not working (1.3.2b)

Oil leak

Brake pedal creeps down while the pedal is held under pressure (3.3.B.1a)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Rear fog lamp not working (1.3.2b)

Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Sub-frame has excessive play in a pin/bush (2.4.G.2)

Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Outer Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp not working (1.3.2b)

Steering rack gaiter split (2.2.D.2d)

Offside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Upper Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front Lower Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)