1987 Toyota MR2

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

General corrosion underneath of the vehicle and covered in underseal

corrosion underside

Brake pedal has insufficient reserve travel (1.1.2 (a))

Nearside Front Suspension component mounting prescribed area is inadequately repaired inner wing (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

corrosion underside

parking brake only just passers test

vehicle has corrosion present on underside

vehicle has had a lot of welding to underside

Brake pedal creeps down when held under pressure (3.3.B.1a)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

corrosion on inner floor areas present

Brake pedal creeps down when held under pressure (3.3.B.1a)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension component mounting prescribed area is excessively corroded inner wing (2.4.A.3)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

corrosion on inner floor areas present

Lower Steering column shaft has slight end float bearing (2.1.3)

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

all tyres perished

front tyres worn on outer edges

offside rear tyre splitting on sidewall

rear tyres worn on inner edges

Nearside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

rear tyres wearing on inner edges

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)