1986 BMW 635

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Speedometer cannot be illuminated (7.8 (c) (ii))

Windscreen washer not working (3.5 (a))

Offside Engine mounting fractured (6.1.8 (a) (ii)) DANGEROUS

Offside Front Hydraulic brake calliper insecurely mounted and braking performance affected retaining clip missing (1.1.16 (c) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Brake warning device malfunctioning or defective (1.1.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases manifold area (6.1.2 (a))

Fuel Pipe/s corroded front to rear lines ()

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bushes bolted to rear subframe (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Suspension component mounting prescribed area is corroded but not considered excessive floor pan area (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis rail (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bushes bolted to rear subframe (5.3.4 (a) (i))