1987 Bedford Rascal

Nearside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Steering column universal joint insecure to the extent there is excessive movement at the mountings (2.1.3 (a) (ii)) DANGEROUS

Nearside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

O/S WIPER SPLIT

REAR STEP INSECURE

slight foot brake travel

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear rear brake binding (3.7.B.1)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

rear brake application uneven oulling to left 61% (3.7.B.2)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Front exhaust heat sheild missing

Nearside Front Inner Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Front Steering component mounting prescribed area is corroded but not considered excessive (2.2.C.1h)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Steering component mounting prescribed area is corroded but not considered excessive (2.2.C.1h)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Battery insecure (1.9.1)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Headlamp aim too low (1.8)

Offside Rear Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front exhaust heat sheild missing

Nearside Front Inner Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Front Steering component mounting prescribed area is corroded but not considered excessive (2.2.C.1h)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Steering component mounting prescribed area is corroded but not considered excessive (2.2.C.1h)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

some corrosion in n/s/f floor

Brakes imbalanced across an axle (3.7.B.5b)

Offside rear brake binding (3.7.B.1)

Rear fog lamp not working (1.3.2b)

some corrosion in n/s/f floor

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Hazard warning switch faulty (1.4.B.1d)

Horn not working (1.6.2a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Obligatory mirror insecure (8.1.1)

Nearside Rear Exhaust mounting missing (7.1.1b)

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Registration plate lamp not working (1.1.5c)

All position lamps not working (1.1.A.3b) DANGEROUS

both rear tyres perrished

Nearside Front Parking brake mechanism/associated mounting prescribed area is excessively corroded (3.1.9)