1987 Ford Capri

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Underside of vehicle corroded

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Horn not working (7.7 (a))

Nearside Rear Hydraulic fluid leaking excessively wheel cylinder (8.4.1 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Central Exhaust mounting defective (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

front cross member corroded but bot in prescribed area

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

front cross member corroded but not in prescribed area

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

front cross member corroded but not in prescribed area

Offside Rear brake fluid leaking from brake drum

Front Suspension component mounting prescribed area is corroded but not considered excessive chassis cross member (5.3.6 (a) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Nearside Steering rack gaiter split (2.2.D.2d)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Nearside rear brake binding (3.7.B.1)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside front brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

Registration plate lamp not working (1.1.C.1d)