1986 Ford Fiesta

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill Bracket (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner Sill Bracket (5.3.6 (a) (i))

rear inner and outer sills going soft emmissions only just met requirements

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Exhaust emissions carbon monoxide content excessive exhaust blowing excessive from front pipe (8.2.1.2 (b))

Front Position lamp not working all front (4.2.1 (a) (ii))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting arch under battery tray (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting next to axle mounting point (6.2.2 (d) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Front Brake hose slightly deteriorated both front flexi pipes perished (1.1.12 (b) (ii))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

throttle sticking causing idle to be high throttle cable may need adjustment

Brake pipe inadequately clipped (3.6.B.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

sill covers fitted