2003 Peugeot 206

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Nail in tyre ()

Offside Rear Nail in tyre ()

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Direction indicator adversely affected by the operation of another lamp (4.4.3 (b))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Tyre(s) of different sizes are fitted on the same axle. 175/7014 remaining tyres 175/6514 (5.2.3 (b))

Fuel tank strap corroded

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge Edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Fuel tank strap corroded

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge Edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Exhaust system insecure (6.1.2 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Power steering component leaking (2.1.5 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive under rear of sill (5.3.6 (a) (i))

Offside Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

o/s handbrake low effort

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Power steering component has slight seepage from a component rack (2.1.5 (a))

Offside Front strut top sticking

tank strap corroding

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear fog lamp not working (1.3.2b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has a minor leak of exhaust gases middle pipe before back box (7.1.2)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Headlamp aim not tested (1.8.A.1c)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Rear Brake load sensing valve seized (3.6.E.3)

Rear Exhaust has a minor leak of exhaust gases middle pipe before back box (7.1.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear rear brake recording little or no effort (3.7.B.5a)

Rear registration plate deteriorated (6.3.1d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)