2008 Mercedes-benz Clc

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge wearing (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge outer edge wearing (5.2.3 (e))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Rear Direction indicator incorrect colour both (4.4.3 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge wearing (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge outer edge wearing (5.2.3 (e))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

slight corrosion starting on underside of vehicle

undertrays fitted

under trays fitted

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Suspension arm ball joint excessively worn rear (5.3.4 (a) (i))

Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure Splits in outer wall (4.1.D.1b) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)