2008 Ford S-max

Bonnet release cable not connected to pull lever

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear exhaust heat shield insecure

Horn not working (7.7 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Bonnet release cable not connected to pull lever

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear exhaust heat shield insecure

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear pads low

Centre stop light inoperative

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)