2009 Ford Ka

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension component corroded but not seriously weakened All (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension component corroded but not seriously weakened All (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Lower Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front wheel slight damage

Nearside Rear tyre perished

Offside Front Front suspension has slight movement at a wishbone pin or bush rear bush (2.5.A.1c)

coil spring corroded all (2.4.C.1b)

wipers not checked no washers

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Headlamp aim too high (1.8)

Nearside Rear Brake cable insecure (3.5.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front wheel slight damage

Nearside Rear tyre perished

Offside Front Front suspension has slight movement at a wishbone pin or bush rear bush (2.5.A.1c)

coil spring corroded all (2.4.C.1b)

wipers not checked no washers

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Rear brake service

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Rear Shock absorber has an excessively worn bush (2.7.4)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Rear brake service

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)