2004 Kia Picanto

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre slightly damaged/cracking or perishing sidewalls cracked (5.2.3 (d) (ii))

Exhaust has a major leak of exhaust gases back box (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength n/s and o/s underneath inner sills (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened corroded insides (1.1.14 (a) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre slightly damaged/cracking or perishing sidewalls cracked (5.2.3 (d) (ii))

Front brake discs corroded

Nearside Front tyre cracked

rear brake discs corroded

Offside Front Brake pipe excessively corroded inner wing (1.1.11 (c))

Offside Front Service brake excessively binding (1.2.1 (f))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front brake discs corroded

Nearside Front tyre cracked

rear brake discs corroded

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Side repeater slightly discoloured (1.4.A.2f)

both rear tyres starting to wear

engine management light on

front coil springs starting to corrode

front discs wearing

rear discs worn

wheel trims fitted

Both rear tyres coming close to legal limit

Engine management light on

Wheel trims fitted

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)