2010 Honda Civic

Nearside Headlamp aim unable to be tested (4.1.2 (b))

Nearside Headlamp insecure (4.1.1 (c))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Headlamp aim too low (4.1.2 (a))

N/S/R TYRE ON 3.0MM AND SLIGHTLY CRACKING + O/S/F TYRE SLIGHTLY WORN ON EDGE

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim unable to be tested (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

N/S/R TYRE ON 3.0MM AND SLIGHTLY CRACKING + O/S/F TYRE SLIGHTLY WORN ON EDGE

REAR BRAKE PADS LOW

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Emissions not tested (8.2.1.2 (d))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

REAR BRAKE PADS LOW

Nearside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b))

Offside Headlamp aim too low (4.1.2 (a))

Offside Obligatory mirror insecure (3.3 (b) (ii))

Nearside Front Body component likely to become detached wheel arch trim (6.2.1 (a) (ii)) DANGEROUS

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine and body under trays fitted not allowing full inspection during the MOT

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Engine and body under trays fitted not allowing full inspection during the MOT

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim too low (1.8)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)