2004 Mercedes-benz Vito

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Oil leak, but not excessive diff (8.4.1 (a) (i))

corrosion under vehicle and suspension components

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Exhaust mounting defective (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive ALL (5.3.6 (a) (i))

Exhaust mounting defective (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material N/S & O/S (1.1.11 (c))

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (5.3.6 (a) (i))

Headlamp light source and lamp not compatible N/S & O/S (4.1.4 (c))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Body component corroded and likely to cause injury (6.2.1 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength N/S & O/S (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust mounting defective (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material N/S & O/S (1.1.11 (c))

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (5.3.6 (a) (i))

front brake pipes rusty

front brake pipes rusty

front outriggers rusty and holed

play offside front inner rack end

r5ear inner sills rusty

rear chassis rusty

rear number plate light inop

rear outer sills rusty

rollbar bushes worn

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

front brake pipes rusty

front brake pipes rusty

front outriggers rusty and holed

play offside front inner rack end

r5ear inner sills rusty

rear chassis rusty

rear number plate light inop

rear outer sills rusty

rollbar bushes worn

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front outriggers rusty and holed

middle rear seat back loose

outer and inner sills rusty

rear chassis rusty

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front outriggers rusty and holed

middle rear seat back loose

outer and inner sills rusty

rear chassis rusty

Front Anti-roll bar has slight play in a pin/bush N/S & O/S (2.4.G.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Unable to inspect rear seats

Brake pipe excessively corroded both front to rears (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Front Anti-roll bar has slight play in a pin/bush N/S & O/S (2.4.G.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Unable to inspect rear seats

Brake pipe slightly corroded both front to rears (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Rear Suspension component mounting prescribed area is excessively corroded N/S & O/S (2.4.A.3)

Brake pipe slightly corroded both front to rears (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S & O/S (2.4.A.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Child seat fitted not allowing full inspection of adult belt

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Tyre worn close to the legal limit (4.1.E.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Five passenger seats present at time of test.

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Brake pipe slightly damaged (2.2.D.2b)

Front disc's corroded plus lipped Rear brake back plates very corroded

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)