2003 Peugeot 206

Central Front Suspension arm pin or bush excessively worn both (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill area (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Nearside Front Prop shaft joint constant velocity boot severely deteriorated clip (6.1.7 (g) (i))

Offside Front Prop shaft joint constant velocity boot severely deteriorated clip (6.1.7 (g) (i))

Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Rear Brake pipe excessively corroded load valve to n/s/r (1.1.11 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

injector leaking

Nearside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Front coil spring broken (2.4.C.1a)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings marked yellow (6.1.B.2)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tie bar/rod has slight play in a ball joint (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tie bar/rod has slight play in a ball joint (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)