2006 Hyundai Matrix

Horn not working (7.7 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Macpherson strut insecure and impairing directional stability top mount broken (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement front trailing arm bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement front trailing arm bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Central Front Seat belt anchorage prescribed area strength or continuity significantly reduced o/s outer sill (7.1.1 (a) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Brake pipe excessively corroded front to rear to flexi (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded from flexi (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pipe excessively corroded from flexi (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases flexi joint (7.1.2)

Nearside Rear Brake pipe slightly corroded to flexi (3.6.B.2c)

Offside Rear Brake pipe slightly corroded to flexi (3.6.B.2c)

front tyres wearing on inside edges

Centre Front Exhaust has a major leak of exhaust gases snaped off (7.1.2)

Nearside Front Lower Ball joint has excessive play (2.2.B.1f)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Emissions not done due to exhaust being broken off

Front Exhaust has a minor leak of exhaust gases flexi (7.1.2)

both front(195/55/15 85v)tyres wearing on inside edge

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

airbag light on(failure item as from 01/04/2012)

possible washer bottle leaking

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Front Brake pad(s) wearing thin (3.5.1g)

airbag light on(failure item as from 01/04/2012)

possible washer bottle leaking

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)