2007 Smart (mcc) Fortwo Coupe

Nearside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement Top mount (5.3.4 (a) (i))

Offside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Fuel cap seal deteriorated

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Outer sill (5.3.6 (a) (i))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Front Inner Drive shaft joint excessively worn CV Boot missing (6.1.7 (c) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Lower Suspension arm insecurely attached Rear (5.3.3 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Fuel cap seal deteriorated

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Outer sill (5.3.6 (a) (i))

Offside Rear Nail in tyre ()

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp light intensity severely reduced bulb incorrectly fitted (4.1.4 (a))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Horn not working (1.6.2a)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Inner Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Drive shaft which forms part of the suspension coupling gaiter damaged, but preventing the ingress of dirt (2.4.G.4e)

srs warning light stays on