2012 Mercedes-benz Vito

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Exhaust mounting defective Mid pipe (6.1.2 (a))

Oil leak, but not excessive Rear diff leaking (8.4.1 (a) (i))

Boot lid component damaged and likely to cause injury Boot struts wont hold boot lid (6.2.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Stop lamp(s) lens defective such that the emitted light is adversely affected (4.3.1 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Loading door likely to open inadvertently or not remain closed (6.2.3 (b) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Exhaust mounting defective Mid pipe (6.1.2 (a))

Oil leak, but not excessive Rear diff leaking (8.4.1 (a) (i))

Horn not working (7.7 (a))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Inner Tyre has a lump, caused by separation or partial failure of its structure sidewall (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Seat belt locking mechanism does not secure or release (5.2.5a)

Offside Rear fog lamp not working (1.3.2b)

Has a oil leak

Front registration plate deteriorated (6.3.1d)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm centre (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Has a oil leak