2001 Toyota Yaris

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear axle corroded

general underbody corrosion

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a) (ii))

Nearside Front Headlamp aim too far to the left (4.1.2 (a))

Exhaust emissions exceed level of metered smoke for a non-turbo charged engine (8.2.2.2 (b))

Horn not working (7.7 (a) (ii))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill within 30cm of rear axle mounting (5.3.6 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge worn to 2mm (5.2.3 (e))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Outer Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Brake pipe slightly damaged (2.2.D.2b)

general corrosion to suspension arms, struts and tie bars

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

general body corrosion

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tie bar/rod rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod synthetic bush deteriorated resulting in excessive movement (2.4.G.2)