2003 Peugeot 206

Front Exhaust has a major leak of exhaust gases cat leaking (6.1.2 (a))

Front Windscreen washer not working (3.5 (a))

Rear Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened both nearside & offside (1.1.14 (a) (ii))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both nearside & offside (1.1.14 (a) (ii))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear tyre is perished

Battery insecure (1.9.1)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear tyre is perished

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake load sensing valve stiff (3.6.E.3)

Brake load sensing valve seized (3.6.E.3)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)