2006 Mazda 6

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Front Headlamp has a product on the lens so that the light output is severely reduced both (4.1.4 (b))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

front wiper blades worn advise new

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

front wiper blades worn advise new

offside rear tyre cracking due to age advise new