2008 Mazda 5

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Headlamp levelling device inoperative (4.1.5 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Slight play/wear at steering rack ends.

Vehicle has heavy surface rust on all underbody components.

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn Rear mounting. (5.3.4 (a) (i))

All tyres in poor condition with bad inner edge wear.

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Slight play/wear at steering rack ends.

Vehicle has heavy surface rust on all underbody components.

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

general underbody surface corrosion including mechanical components

Central Driver's view of the road through the swept area of the windscreen materially affected by an obstruction (3.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

front lower underbody panel cover, and both front inner wing covers loose

general underbody surface corrosion including mechanical components

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

engine management lamp on

engine, lower sill and underbody covers fitted

general underbody mechanical component heavy surface corrosion

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

engine management lamp on

engine, lower sill and underbody covers fitted

general underbody mechanical component heavy surface corrosion

Items removed from driver's view prior to test ()

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

general underbody surface corrosion including mechanical/suspension components

offside rear tyre edge wear and slight irregular feel/wear

rear wiper blade splitting

slight irregular feel/wear at both front tyres

plastic covers fitted at engine, underbody and sills.

underbody of vehicle and all components have heavy surface corrosion.

Nearside Front front brake application uneven (3.7.B.2)

Offside front brakes release unevenly (3.7.B.4)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

battery has dried acid accumulating.

engine management light illuminated.

exhaust heat shield insecure.

front tyres in poor condition with edge wear suggest wheel alignment check.

plastic covers fitted at engine, underbody and sills.

underbody of vehicle and all components have heavy surface corrosion.

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Vehicle's internal headlight adjuster altered to recheck lights

engine management lamp on

engine, lower sill and extensive underbody covers fitted not allowing full inspection

offside rear tyre has irregular wear/feel, inner edge worn and general wear @2.5/3mm ( limit 1.6mm )

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

cut in tread at nearside front.

extensive plastic covers fitted at engine, underbody and sills.

extensive underbody surface corrosion to all comonents.

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

cut in tread at nearside front.

extensive plastic covers fitted at engine, underbody and sills.

extensive underbody surface corrosion to all comonents.

air bag lamp on/flashing

engine, underbody and part sill covers fitted not allowing full inspection

rear exhaust heat shield loose/insecure

rear wiper blade split

suspect offside rear shock absorber leaking fluid ( wet )

Nearside Rear Direction indicators slightly discoloured (1.4.A.2f)

Offside Rear Direction indicators slightly discoloured (1.4.A.2f)

extensive plastic covers fitted at engine, underbody and sills.

rear wiper blade split/torn.

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Direction indicators slightly discoloured (1.4.A.2f)

Offside Rear Direction indicators slightly discoloured (1.4.A.2f)

extensive plastic covers fitted at engine, underbody and sills.

rear wiper blade split/torn.

oil level too high.