2008 Toyota Aygo

Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Hazard warning switch faulty (4.4.2 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Axle /suspension arms (5.3.6 (a) (i))

Rear Service brake excessively binding (1.2.1 (f))

Rear Service brake lagging in operation (1.2.1 (d))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Hazard warning switch faulty (4.4.2 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Axle /suspension arms (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Play in steering rack inner joint(s) ()

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Play in steering rack inner joint(s) ()

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Hand brake performance just met requirements

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Windscreen wiper blade defective split (3.4 (b) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Hand brake performance just met requirements

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Windscreen wiper blade defective split (3.4 (b) (i))

Front Anti-roll bar linkage ball joint dust cover severely deteriorated n/s & o/s (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Anti-roll bar linkage ball joint dust cover severely deteriorated n/s & o/s (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both rear pipes (1.1.11 (c))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded main (3.6.B.2c)

Front discs corroded

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)