2013 Chevrolet Captiva

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

parking brake only just reached the required efficiency. adjustment/ service required

Offside Front Tyre worn close to legal limit/worn on edge 2.3mm (5.2.3 (e))

Front Windscreen wiper does not clear the windscreen effectively both wipers split (3.4 (b) (ii))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge 2.3mm (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Far rear seats folded away in a stored position time of test

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Outer Brake pad(s) wearing thin Strong advise .worn very low (1.1.13 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Stop lamp(s) with a multiple light source up to 1/2 not functioning centre (4.3.1 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)