2003 Mazda MX-5

Brake pipe corroded, covered in grease or other material all covered in underseal (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened all x4 arms (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced and covered in underseal (6.1.1 (c) (i))

underside covered in underseal

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Brake pipe corroded, covered in grease or other material all covered in underseal (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area damaged but not considered excessive outer sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Suspension arm corroded but not seriously weakened all x4 arms (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced and covered in underseal (6.1.1 (c) (i))

underside covered in underseal

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Vehicle structure is fractured but structural rigidity is not significantly reduced sill (6.1.1 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

vehicle underbody covered in underseal

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Coolant below min mark

Vehicle underside rusty

Coolant below min mark

Vehicle underside rusty

Windscreen washer provides insufficient washer liquid (3.5 (a))

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Emissions not tested broken exhaust centre silencer (7.3.A.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside rear tyre inner sidewall deteriorating and splitting

Offside Front Tie bar/rod insecure (2.4.G.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside rear tyre inner sidewall deteriorating and splitting

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front brake discs corroding

Rear brake discs slightly pitted

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

screw in o/s/r tyre

screw in o/s/r tyre