2003 Mazda MX-5

Front both wings corrosion

Front subframe corroded

Inner Both inner sills corroded

Nearside Front steering arm slight play

Offside Front steering arm slight play

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear axel corroded

Rear suspension arms corroded

all over general under body corrosion

exhaust corrosion

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Front Seat belt anchorage loose (7.1.1 (b))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Seat belt anchorage loose (7.1.1 (b))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front both wings corrosion

Front subframe corroded

Nearside Front steering arm slight play

Offside Front steering arm slight play

Rear axel corroded

Rear suspension arms corroded

all over general under body corrosion

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis rail (6.1.1 (c) (i))

Nearside Position lamp not working (4.2.1 (a))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner and outer sills (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner wheel arch (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Floor to sill (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner and outer sills (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner wheel arch (7.1.1 (a) (i))

Engine warning light on

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened Upper and lower (5.3.3 (b) (i))

Lower Front wings corroded l

Offside Rear Sub frame bush in a poor condition

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened Upper and lower (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust has a major leak of exhaust gases (7.1.2)

body has corrosion on both sills also on exhaust and suspension

brakes binding

Brake pipe excessively corroded front to rear (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

body has corrosion on both sills also on exhaust and suspension

brakes binding

Child seat fitted not allowing full inspection of adult belt

OFFSIDE REAR TYRE CUTS IN SIDEWALL..NO CORDS SHOWING

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

front and rear pads low

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp aim too low and too far to the left. (1.8)

Offside Front Headlamp aim too low (1.8)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)