2004 Mazda RX-8

general underbody corrosion and undersealed

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Obligatory mirror slightly loose (3.3 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

previous weld repairs and heavily undersealed

Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Power steering malfunctioning (2.1.5 (a))

Offside Front Lower Suspension component ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Obligatory mirror slightly loose (3.3 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

previous weld repairs and heavily undersealed

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Headlamp cleaning device Inoperative

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Rear Anti-roll bar linkage fractured (2.4.G.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage fractured (2.4.G.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

front brake pads starting to wear low

Front Brake pad(s) wearing thin (3.5.1g)

front brake discs corroded on inside faces

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Front Brake pad(s) wearing thin (3.5.1g)

battery flat

front brake discs corroded on inside faces

front brake pads getting low

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

front brake pads getting low

Offside Inner Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Inner Front Tyre worn close to the legal limit (4.1.E.1)