2004 Honda Civic

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Anti-roll bar linkage ball joint excessively worn both side (5.3.4 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both side (5.3.6 (a) (i))

Front Suspension arm ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Nearside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Anti-roll bar linkage ball joint has slight play both (5.3.4 (a) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Anti-roll bar linkage ball joint has slight play both (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Inner Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Windscreen washer not working (3.5 (a))

Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Inner Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Rear Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both side (4.1.4 (b))

Exhaust emissions likely to be affected by an exhaust leak rear exhaust box damaged (8.2.1.1 (b))

Offside Front Position lamp not working (4.2.1 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output faded (4.1.4 (b))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Headlamp has a product on the lens but not seriously reducing light output faded (4.1.4 (b))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Outer Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is distorted but not considered excessive (2.4.A.3)

plastic cover sills and exhaust heat shields fitted as standard,obscuring some testable components.

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Child seat fitted not allowing full inspection of adult belt

Front wiper starting to split

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside front anti roll bar link starting to break

Offside front anit roll bar link starting to break

Offside rear anti roll bar link starting to break

Offside Rear rear brake binding (3.7.B.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front front brake grabbing slightly (3.7.A.2b)