2010 Honda Integra

Rear Brake hose has slight corrosion to ferrule Both sides . (1.1.12 (f) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Front Brake hose has slight corrosion to ferrule Both sides . (1.1.12 (f) (i))

Rear Brake hose has slight corrosion to ferrule Both sides . (1.1.12 (f) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Bumper loose .

All suspension components corroded .

Front Bumper slightly loose .

all suspension componants corroded

General corrosion to underbody and components

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Underside of vehicle has lots of surface corrosion (6.1.1 (c) (i))

Nearside Rear Suspension component mounting repair covered in underseal Floor pan (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Floor pan (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear fog lamp does not emit a steady red light (4.5.4 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced Underside of vehicle has lots of surface corrosion (6.1.1 (c) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Suspension component mounting repair covered in underseal Floor pan (5.3.6 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Floor pan (5.3.6 (a) (i))

Advise sill cover's fitted

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive floor (7.1.1 (a) (i))

Windscreen excessively tinted but not adversely affecting driver's view (3.2 (b) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Advise sill cover's fitted

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive floor (7.1.1 (a) (i))

Windscreen excessively tinted but not adversely affecting driver's view (3.2 (b) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

underside has surface corrosion

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Side skirts fitted to outer sills

Some under vehicle suspension components becoming corroded.

rear tyres worn unevenly

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

exhaust cracked around (cat to centre join )

rear tyres worn unevenly

Offside Front Front suspension has a loose unit in the upper support bearing assembly (2.5.B.3b)